NOTICE OF SOFTWARE RELEASE: 882IS V1.10.00 - 6/27/2025

Non-Legally Relevant Changes:
•      IO Module – Add a baud rate setting to allow 57600 or 115200 – Git #676
•      Application – Add peak hold application – Git #574
•      Sleep Timer – Indicator does not go to sleep after initial configuration – Git #685
•      Audit – Modifying the gravity setting should increment the config counter – Git #677
•      Menu – When setup is password protected it is impossible to submit password to reenter


NOTICE OF SOFTWARE RELEASE: 882IS V1.10.00 - 5/14/2024

Non-Legally Relevant Changes:
• 	Test Menu – Typo in the battery counts value
• 	Warm up mode – Can still query weight using the S command 
• 	Streaming – When a polarity sign is included in the weight token increases the number of digits by 1 
• 	Streaming – Polarity included in weight token if overload shows negative sign 
• 	Configuration – Port settings not always applied when exiting from setup mode 
• 	Setting the ETH.SERVER. PORT does not change it from 10001 
• 	Menu – The accumulator threshold parameter is not shown in the menu 
• 	Printing – The <SU> token isn’t implemented properly 
• 	EOL Delay – Not working on IO module ports 
• 	MRMI – EDP command to set the range 3 streaming units is missing 
• 	Analog Output – When error action is set to hold, it does not hold in some instances 
• 	Power Save mode – Add configurable sleep timer 
• 	Streaming – Able to stream frames with a negative zero indication on secondary 
• 	Sleep + Stream – When in the medium sleep mode, indicator still streams weight


NOTICE OF SOFTWARE RELEASE: 882IS V1.09.01

Non-Legally Relevant Changes:
• 	Analog Output – Communications error at certain weight
• 	Audit Trail – Configuration counter increments incorrectly with KSAVE and KEXIT 
• 	Fieldbus – Error with commands being sent to 882IS 