NOTICE OF SOFTWARE RELEASE: 680HE Firmware v1.05.03
07/10/2025

Non-Legally Relevant Changes
•    Add support for upcoming ADC revision change


NOTICE OF SOFTWARE RELEASE: 680HE Firmware v1.05.02
11/21/2024

Non-Legally Relevant Changes
•    Corrected issue where MACID was not populating correctly


NOTICE OF SOFTWARE RELEASE: 680HE Firmware v1.05.01
11/15/2024

Non-Legally Relevant Changes
•    CPU board will not boot properly without a battery installed
•    Added support for new display drivers on the display board


NOTICE OF SOFTWARE RELEASE: 680HE Firmware v1.04.00
08/05/2022

Non-Legally Relevant Changes
•	Setting STRM.FORMAT#1 to RLWS or CARDNAL eliminates the positive token
•	Going in and out of the user menu causes indicator to reinitialize and clear the tare
•	Analog output – tweak menu values not limited to 65535 in the menu
•	EDP commands S and SF#1 do not return anything with STRM.FORMAT#1=CARDNAL
•	Batching messages prevent any keypress while being displayed
•	RS485 Duplex parameter missing from the menu
•	PRINT.DESTINATION default should LOCAL not REMOTE
•	Menu – Missing the ZERONLY keypad locking parameter
•	REMOTE.PRINTDESTINATION parameter is not reset during a reset config
•	Analog Output – Does not assume the error action when entering config
•	SU print token is not stripping the decimal point
•	Local/Remote keypress functionality should work with EDP commands
•	P and ZZ commands do not return displayed value in user menu
•	ZZ command – If the units are not LB or KG, it always sets the bit for KG
•	Menu – navigation broken at analog output, tweak zero, and tweak span
•	Extra terminator for BATSTATUS command
•	ZZ and P commands not working in setup mode
•	Max date value format is incorrect
•	DUMPALL response has two OK’s at the end
•	Pressing down on the negative sign freezes the indicator in the string editor
•	Pressing down arrow on a 6-digit number, the negative does not show on the screen
•	KEYHOLDTIME parameter not being applied correctly
•	KPRINT returns ?? in some scenarios
•	Fixing the time and date menu
•	SF#1 returning nothing with weight on the display
•	P and ZZ commands do not include decimal points
•	Add multiple updates from 680 to the 680HE
•	Menu – show start of IP address when dropping into the menu, not the middle
•	Menu - Fix the ethernet client and server menu order
•	Menu – Pressing down on MAXDATE moves right instead of down