NOTICE OF SOFTWARE RELEASE: 680 Firmware v1.16.03
01/27/25

Non-Legally relevant changes:
•    Resolved an issue with the tweak zero and span menu truncating the 5 digit of the tweak value


NOTICE OF SOFTWARE RELEASE: 680 Firmware v1.16.02
12/19/25

Non-Legally relevant changes:
•     Resolved an issue with HARDWARE EDP command not working with analog output card


NOTICE OF SOFTWARE RELEASE: 680 Firmware v1.16.01
12/10/25

Non-Legally relevant changes:
•     Resolved an issue with remote scale connections not starting


NOTICE OF SOFTWARE RELEASE: 680 Firmware v1.16.00
8/29/225

Non-Legally relevant changes:
•     Added batch mode presets
•     Changed number of setpoints from 8 to 20


NOTICE OF SOFTWARE RELEASE: 680 Firmware v1.15.01
1/13/25

Non-Legally relevant changes:
•     Update firmware to handle new rev of ADC chip


NOTICE OF SOFTWARE RELEASE: 680 Firmware v1.15.00
09/24/2024

•     If remote receives unknown unit, the units token is dropped 
•     Analog output – Asking the value of ALG.OUTPUT#1 resets the TWZERO and TWSAPN values
•     USB Device – If USB port is streaming but there is no VCP connection other ports are blocked 
•     Remote Scale – Underload does not work with RLWS, Cardinal, and WeighTronix formats


NOTICE OF SOFTWARE RELEASE: 680 Firmware v1.14.00
01/15/2024

•      Display test feature for LED display
•      Keypad test feature for production
•      Changing SC.OVERLOAD#1 to defaults when in OIML or Canada mode does not increment the config counter
•      Add Australia mode


NOTICE OF SOFTWARE RELEASE: 680 Firmware v1.13.00
11/16/2023

•	Add Minebea format to Remote section as an option
•	Correct error with custom units
•	AZT works incorrectly when displaying non-primary units 
•	Printing on a streaming port does not work properly
•	CONTACT.LASTCAL – cannot set the parameter in the menu 
•	Tare rounding bug


NOTICE OF SOFTWARE RELEASE: 680 Firmware v1.12.00
11/16/2022

• 	Printing – Corrected print format limit that caused long formats to be printed incorrectly
• 	Analog Output – 0mA lock issue
• 	Analog Output – 4-20mA output stops sending after configuration
• 	Setpoints – Changing setpoint value in weigh mode by EDP command doesn’t work
• 	EOL Delay will not work on stream formats without <CR><LF> termination
• 	USB – If ECHO is set to OFF, port will lock
• 	EDP – Receiving two OK’s after DUMPALL response
• 	EDP – ZZ command response incorrect when units are not LB or KG
• 	EDP – Change INPUT commands to TRIGGER
• 	Setpoints – Setpoint DIO not working properly
• 	Printing – Tertiary unit tokens do not work

NOTICE OF SOFTWARE RELEASE: 680 Firmware v1.11.00
03/04/2022

•	RS485 not functioning correctly
•	Display tare function weigh gets cut off
•	Remote print destination EDP command not being reset after a RESETCONFIGURATION command
•	Setpoint – Preact learn interval count does not work
•	SPV token always prints zero
•	SPM token always prints Gross
•	KDISPACCUM EDP command cuts off leading digits
•	KDISPACCUM EDP command while accumulator is up causes strange behavior
•	Incorrect error message shown for low/no battery
•	Multiple error message strings missing
•	BATSTOP has incorrect translation
•	Analog output tweak zero/span menu shows “?? Invalid”

